More Views
Aeotec Z-Wave Water Sensor 6
Details
Flood sensor. Leak sensor. Safety sensor.
We protect our homes in so many ways. With smoke sensors, door locks, and security systems. But more homes are damaged each year by flooding and burst or leaky pipes than by devastating fires or burglaries.
Water Sensor 6 can help avoid costly water damage, using Z-Wave Plus to silently monitor areas of your home at risk of leaks or floods and then taking action and letting you know the moment water is detected.
Water Sensor 6 monitors your home.
Always ready to detect the first hint of water where it shouldn't be...
Leaks & bursts.
Water Sensor 6 can detect minuscule amounts of water – as little as 0.5mm / 0.02” of water. That makes it your first line of defence against damaged plumbing.
Floods.
Whether a small amount or large, Water Sensor 6 also is perfect at protecting against the floods you can anticipate, such as water heaters, pumps and in basements.
Overflows.
Accidents happen but that doesn’t make the damage caused by forgotten taps any less expensive. Water Sensor 6 can alert you to the water you’ve forgotten to turn off before it’s too late.
Water Sensor 6 helps protect your home.
Water Sensor 6 doesn’t just detect when a pipe has burst or is leaking, it can instigate measures to help limit the amount of damage caused.
Using the power of a Z-Wave Gateway Controller, you can put Water Sensor 6 in control of other Z-Wave devices to do almost anything...from sending alerts to turning off electricity and water valves in order to protect your home and your loved ones.
Auto-close water valves.
In the event of a pipe burst, use Water Sensor 6 to turn off electronic water valves via Z-Wave.
Turn on sump pumps.
When water is detected, turn on electronic sump pumps your gateway or Z-Wave switches.
Auto cut off power.
Water and electricity don’t mix. Automatically turn off Z-Wave enabled electronics and appliances.
Leak protection anywhere.
Leaks often happen in the worst of places. Behind things, under things, and in all those hard-to-see places... meaning you often won’t notice a leak until it’s far too late and major damage has already been done.
That’s why Water Sensor 6 is so slim – it’s only 8.5cm wide, 3.8cm deep and 2.4cm tall. That means Water Sensor 6 will fit and blend in wherever you need it, whether that’s in a hard to reach space or one where it can be seen.
The leak sensor with sensors.
Water Sensor 6 has been designed to protect your home and it’s also been designed to make your smart home smarter. Three separate sensors are crafted into each Water Sensor 6.
Each of these sensors can be used to create intelligent home control scenarios via your Z-Wave Gateway Controller, including water detection, management of underfloor heating, HVAC control and driveway heating.
Water sensor.
4 gold tipped water probes actively monitor for leaks and drips.
Vibration sensor.
Tamper and emergency events are confirmed by an algorithm that includes vibration detection.
Temperature sensor.
Crafted for heating management, an inbuilt temperature sensor can monitor temperatures between -20ºC and 100ºC.
The finer details
- RF Protocol: Z-Wave Plus.
- Supports Over-the-Air firmware updates.
- RF Frequency: 921.42Mhz ‐ AU/NZ approved RF for Z‐wave.
- Wireless range up to 30m without obstacles.
- Monitor and protect against leaks and floods in real-time.
- Super accurate; can detect as little as 0.03% of an inch of water.
- Inbuilt temperature sensor can monitor between -20º C to 100º C.
- Inbuilt 60 decibel siren to notify you of a leak or emergency.
- Optional Water Sensor 6 Dock also available.
- 2.5 years battery life (included) before replacement required.
- Water proof.
- Dimensions: 85mm x 38mm x 24mm.
Additional Information
| Name | Aeotec Z-Wave Water Sensor 6 |
|---|---|
| Brand | Aeotec |
| Model | ZW122 |
| Product Manual | N/A |
| Warranty | 12 Months (+ Free 12 month extended warranty) |
| RRP | $89.00 |
Check items to add to the cart or select all
